Enable Users in YEDIS
YEDIS authentication is based on passwords. Each client connecting using the YEDIS API should provide a valid password in order to execute any command successfully.
NOTE: YEDIS implements a password-only authentication scheme. From the Redis security docs page ("Authentication feature" section), the open source version of Redis does not try to implement authentication, providing a small layer of authentication that can optionally be enabled in the
1. Enable YEDIS authentication
You can enable password-based authentication in YEDIS API using the CONFIG command.
To do so, connect to the cluster using
redis-cli and run the following command:
127.0.0.1:6379> CONFIG SET requirepass "password"
2. Connect with redis-cli
redis-cli, connect to the cluster again using
redis-cli and run the
PING command (or any other command).
(error) NOAUTH PING: Authentication required.
You would need to authenticate the client (
redis-cli in this case) by running the AUTH command:
127.0.0.1:6379> AUTH password
Subsequently, running any command would succeed:
3. Changing authentication credentials
YEDIS allows for multiple passwords (up to 2) to be accepted. This enables performing a graceful change of password without experiencing any application outage. Note that this requires knowing the old password.
Let us assume that the old password is
old-password and the new password you intend to change it to is
new-password. The preferred sequence is:
- Add a new password
127.0.0.1:6379> CONFIG SET requirepass "old-password,new-password"
This enables connecting to the database using both passwords.
- Change password used by the application tier
This would involve changing the config or pushing an updated binary to the application tier so that it now connects using
- Drop old password
127.0.0.1:6379> CONFIG SET requirepass "new-password"